Do you have a special piece of jewelry that needs a professional touch?
At ESG Diamonds, we perform professional jewelry repairs at our Florida showrooms. From minor repairs to more complex fixes, our team can help correct every damage and bring your piece of jewelry back to life.
We're able to help with replacing your swivel clasps, shortening your bracelets, and reconditioning your stone settings amongst other repairs.
experience professional
jewelry services
Walk into our showroom today to experience professional jewelry services from ESG Diamonds.
Our jewelry repair services include:
• Cleaning
• Polishing
• Electroplating/Dipping (Rhodium, Silver, and Gold)
• General Jewelry Repair
• Resizing
• Soldering / Welding
• Stone setting
• Watch Battery Replacement
• Watch Repair
TYPES OF METALS
We repair all common types of metal: Silver, Gold and Platinum. We use a mass spectrometer to determine what metal we are repairing. We use a laser welder that allows to make “pin point” welds that can be seen with the naked eye.
Ring Sizing
To size a ring, appropriate metal will be added or removed to adjust a ring to the desired size.
Shank
The shank, also known as the band, is the part of the ring that is under the finger (palm side) and is connected to the top of the ring.
Rhodium Plating
Rhodium plating is a bright white plating finish added to white gold rings. This is what gives the ring a much whiter appearance but will wear off.
Head
The head is the primary object that holds the diamond or stone. It is usually 14K white gold and is made up of prongs, typically 4 or 6 prongs.
Tip
A tip is the very top of the prong. It is bent over the top of the diamond or stone to hold it in place. Tips will wear down and get thin. Tips should be replaced every 7 to 10 years.
Prongs
The prongs hold the stone in place and usually go from the bottom of the stone to the top. Sometimes prongs are referred to as claws.
V Prongs
V Prongs are sometimes on stones that have a point, like the two points of a marquise shaped stone, or at the four corners of a square shaped stone.
Diamond & Gemstone Replacement
Diamond & gemstone replacement is generally needed due to the loss of a secondary accent on the piece of jewelry. When a ring or bracelet’s prongs or tips are worn out, stones loosen or completely detach.
Solder
Solder is a low melting alloy used for joining two metals together.
Laser Weld
Laser soldering fuses two metals together without a flame or torch, used for delicate repairs.
Bail
The bail is the top part of a pendant that the chain slides through.
Chain Tip
The chain tip is the flat metal piece with holes that the clasp can attach to.
Jump Ring
A jump ring is a plain round wire ring at the end of a chain which will hold the clasp.
Engrave
To engrave is to cut or scratch into the metal to personalize the piece.
Earring Repairs
A friction post is a straight post connected to the back of the earring which will pass through the ear lobe and is secured with a push-on back.
A screw post is a straight, threaded post connected to the back of the earring which will pass through the ear lobe and is secured with a nut that will screw onto the post.
Tennis Bracelet Repair
Tennis bracelet repair can include joint, link, hinge or clasp repair.
Book Appointment
Pair large text with a full-width image to draw attention to an important detail of your brand or product line.